Repeater Assembly

Our first set of cans.  We had a six pack.

Here I am KC9JOY, Nick.  Working on the repeater at N9PUGS' house.

Both working hard.  We have Norm N9EVM and Marvin KC9JEB patching a hole in the front of the case.

Here is the partial setup of the repeater.  The transmitter is not in at this point.

If you look hard you will see Greg N9PUG on the top of the tower 130' above the ground and loving it.  Also if you look hard at the

middle of the picture you can see that the antenna being raised to the top.

Here is Greg putting the antenna and mast pole together.

Greg is taking this picture from the top of the tower.  Marvin and Norm are looking up.  At this time

I am on my way to Ace Hardware to pick up more parts to attach the antenna to the tripod.

The final installation of the antenna.  Shortly after this photo was taken the wind picked up but nothing happened.  All held together.

I would like to say that no time during the installation was anyone hurt.